Call me back | My basket | Checkout | Add to email list

     You are here: Website » Knowledge base

« back to website

DL2 / Installation

Installing The unit

Mounting

As the DL2 contains accelerometers, it is important that the unit is mounted on a flat, fairly level surface in the vehicle. A small amount of tilt can be compensated for in the software, however, large tilt angles cause loss of resolution and increased noise due to vertical vibration. Click here for instructions on compensating for accelerometer tilt.

Just as importantly, the logger must be mounted "squarely" in the vehicle with the buttons facing towards the back of the vehicle. If the unit is mounted at an angle to the direction of travel for the vehicle, then the unit's measurements will be inaccurate. Acceleration errors caused by mounting the unit at an angle to the direction of travel cannot be compensated for, so it is important to get it right.

If the logger is to be fitted permanently in the vehicle, then the logger can be secured using two mounting lugs. These are fitted by screwing them into the two holes in the side of the logger and then screwed into the vehicle. The logger can be removed from the vehicle by removing the mounting screws which hold the lugs to the unit, and then lifting the meter to remove it from the lugs. Please note, no screws or lugs are supplied with the DL2, the holes in the side of the DL2 are designed for M3 sized screws.

If the logger is to be moved frequently from one vehicle to another, then BluTak™ or Velcro™ tape can be used as an alternative to the mounting lugs, these are NOT supplied with the unit.

Power

The DL2 has a power input on Pin 7 (G) of each of the 4 connectors. Only one of these needs to be connected to the power supply. You will have to wire these into the connectors yourself. For more information on the connectors, click here. The DL2 uses a 12V power supply, this can be connected to the engine wiring loom. You must use a fused supply with a fuse rating of no more than 1 amp. It is also highly recommended that the unit has it's own external power switch so it can be easily turned off. This is to prevent any draining of the battery, or any damage to the unit when the engine is turned on or when the car is being cranked over. It is recommended that you only turn the unit on once the engine is running. It is possible that leaving the DL2 turned on during cranking may corrupt the data in the logger.

Also please note that in all cases the GPS receiver is powered on whenever there is power to the main unit - it does not turn on and off with the main unit, so if the DL2 is left connected to the battery it will flatten it.

Alternatively, the DL2 can be powered from a separate battery if required - this is often appropriate for temporary installations where a cigar lighter is not available. The DL2 requires a minimum of 10v and draw about 100mA-200mA, so the size of the battery should be chosen to give sufficient run time. For example a 1Ah battery would give about 5 hours operation. Because of the current supply requirements only rechargeable batteries should be used, you cannot use disposable batteries. If you do require a battery pack, Race Technology keep a wide selection in stock - call us with your requirements.

Start the vehicle, wait a few seconds then connect the power lead to the unit. After a few seconds, the "Power" LED will come on and the "status" light will flash. Wait for a few minutes to enable the GPS to obtain a good positional lock. Once the receiver has a lock, the Lock light on the DL2 will start flashing every second, first a slow flash, then a fast "blink" for each satellite it has locked on to. The first time the DL2 is used it will take a while to lock on, subsequent times the process will be faster.

Page last modified on January 22, 2015, at 10:35 AM