Call me back | My basket | Checkout | Add to email list

     You are here: Website » Knowledge base

« back to website

HowDoI / SetUpTheDisplay

HowDoI.SetUpTheDisplay History

Hide minor edits - Show changes to markup

December 17, 2010, at 12:31 PM by racetec -
Deleted lines 30-33:

step 4: If you do not require any data to be displayed on one of the channels, simply enter the appropriate drop down menu, and select "Leave Blank".

Deleted lines 32-37:

The area of the DASH2 screen that would usually display this channel, will now be left blank.


May 28, 2008, at 01:14 PM by racetec -
Changed lines 3-4 from:

step 1: Enter the DASH2 configuration tool in the RT software (see the section on configuring RPM), and click on the "Setup screens" tab.

to:

step1: Enter the DASH2 configuration tool in the RT software (see the section on configuring RPM), and click on the "Setup screens" tab.

Changed lines 7-8 from:

step 2: The DASH2 allows you to configure up to five different displays to a show a variety of data. Use the drop down menu in the top, left hand corner of the "Setup screen" window to select which of these displays you wish to configure.

to:


step 2: The DASH2 allows you to configure up to five different displays to a show a variety of data. Use the drop down menu in the top, left hand corner of the "Setup screen" window to select which of these displays you wish to configure.

Changed lines 15-16 from:
 step 3: You will now need to select the data that you want to have displayed on the chosen screen. To do this, use the three appropriate drop down menus, as shown below:
to:


step 3: You will now need to select the data that you want to have displayed on the chosen screen. To do this, use the three appropriate drop down menus, as shown below:

Added lines 21-22:


Added lines 27-28:


Changed lines 31-32 from:

step 4: If you do not require any data to be displayed on one of the channels, simply enter the appropriate drop down menu, and select "Leave Blank".

to:

step 4: If you do not require any data to be displayed on one of the channels, simply enter the appropriate drop down menu, and select "Leave Blank".

Added lines 35-36:


Added lines 41-42:


September 26, 2007, at 06:14 PM by racetec -
Added lines 1-35:

How do I set up what is displayed on the DASH2?

step 1: Enter the DASH2 configuration tool in the RT software (see the section on configuring RPM), and click on the "Setup screens" tab.

step 2: The DASH2 allows you to configure up to five different displays to a show a variety of data. Use the drop down menu in the top, left hand corner of the "Setup screen" window to select which of these displays you wish to configure.

 step 3: You will now need to select the data that you want to have displayed on the chosen screen. To do this, use the three appropriate drop down menus, as shown below:

As you select the changes that you wish to make, the picture of a DASH2 at the top of the window will alter accordingly:

N.B. When used as a stand alone piece, without being attached to a data logger, only the "DASH2 analogue" channels will be available for use.

step 4: If you do not require any data to be displayed on one of the channels, simply enter the appropriate drop down menu, and select "Leave Blank".

The area of the DASH2 screen that would usually display this channel, will now be left blank.

N.B. When configuring the DASH2 from a PC, always ensure that the correct serial port is selected from the menu in the bottom, left hand corner of the "Setup screens" window.

Page last modified on December 17, 2010, at 12:31 PM