Search found 6 matches
- Tue Jun 23, 2009 10:45 pm
- Forum: General software support
- Topic: Issue getting ECU data to log & display
- Replies: 1
- Views: 6557
Issue getting ECU data to log & display
I recently purchased a DL1, Dash3 and ECU interface. I have an M4 Motec ECU. In the ECU I have set data set 5 and 9600 baud for the telemtery. I initially configured the Dash3 to display certain ECU related data, but at a recent test day got no ECU data on the dash3. I've just reviewed one of my run...
- Tue Jun 23, 2009 11:38 am
- Forum: General software support
- Topic: Lap and Sector screens change on Dash3
- Replies: 8
- Views: 13312
- Mon Jun 22, 2009 7:56 pm
- Forum: General software support
- Topic: Problem with Laptimer in Dash3/DL1 combination
- Replies: 16
- Views: 28071
The connect to other hardware for dash 3 does not exist and I cannot find it anywhere. I am experiencing the same issues. I saved the track marker file as the .LAP to the root. I can't compare the DL1 settings as I cannot open the page shown. The only config for DL1 are update rates, start/stop, fi...
- Mon Jun 22, 2009 11:02 am
- Forum: General software support
- Topic: Lap and Sector screens change on Dash3
- Replies: 8
- Views: 13312
- Mon Jun 22, 2009 10:09 am
- Forum: General software support
- Topic: Lap and Sector screens change on Dash3
- Replies: 8
- Views: 13312
This is possible. If you only have a lap marker and skip the sector markers in the DL1/DL2 configuration then just the lap time will be displayed. If you want to perform sector analysis after wards, it is easy to set up sector markers in the Analysis software I'm still trying to get my DL1/Dash3 se...
- Mon Jun 15, 2009 1:47 pm
- Forum: General software support
- Topic: Turn off shift ligths on Dash3
- Replies: 0
- Views: 27342
Turn off shift ligths on Dash3
I used to have a shift light which had 3 LEDs - which has now been replaced by a DL1 and Dash 3. I had it set up so the first light came on below a set RPM - it was a useful quick indicator if i could use a lower gear - without needing to rev the hell out of the engine on the next lap to find out. T...