Hi: Could somebody explain how serial data logging works on the DL1 MK3? I have sensors that output serial data in ASCII form, and I would like the DL1 MK3 to log this stream, for later processing. I've hooked up a serial terminal to serial port 1 of the DL1 and sent data @115200 bauds while the uni...

Hi Martin:

Thanks for the reply. I'm preparing the files, should be in your inbox within a few minutes.

Jean

Support wrote:Could you please email a lap marker file and run file to mhill @ race-technology.com so I can investigate for you.

Regards,
Martin

Hi,

Thanks for the reply. Yes I'm running the latest firmware available off the website.

Jean

Jet-Tech wrote:Have you tried updating to the latest firmware?

Hi, Could somebody guide me through getting the lap timing to work on a DL1 mk3? I've followed the instructions online to generate a lap file. Actually this is not a lap but rather an itinerary where start and stop markers do not loop back. I've saved the lap file onto the DL1's root and drove the i...

Hi: What is the "internal" folder intended for on the SDcard of a DL1 MK3? It contains RT RTCGxxx.TXT with a sequential number. The content of the files is as follows: " 192 00495 194 00496 196 00495 198 00496 200 00495 202 00496 " Does this shows that some internal errors are ha...

Hi: I have a DL1 MK3 with the 20Hz GPS option. I've enabled some parameters to be logged at 20Hz. When sending the configuration file to the logger I get the following warning: "GPS rates are set to >10Hz and internal GPS only runs at a maximum of 10Hz" Why is this message generated when I...