Dash 2 sensors set up
Posted: Thu Aug 09, 2018 12:02 pm
Afternoon all
So I've been trying myself to configure my dash 2 but I'm struggling with the temperature sensor, as I can't get the dash to read it correctly. I have tried calling up a standard sensor, a Bosch from the drop down menu but it doesn't work. I've also tried creating an equation, taking the readings direct from the DTA ECU, and adding these values into the table. In both situations above I end up with a staggnet reading.
Car is running a Ford Zetec with standard sensor taken from the thermostat housing.
Haven't tried the fuel gauge yet but I assume that I may come across the same issues, so was keen to rectify one before moving into the next.
Any help/guidance would be greatly appreciated.
Thanks
So I've been trying myself to configure my dash 2 but I'm struggling with the temperature sensor, as I can't get the dash to read it correctly. I have tried calling up a standard sensor, a Bosch from the drop down menu but it doesn't work. I've also tried creating an equation, taking the readings direct from the DTA ECU, and adding these values into the table. In both situations above I end up with a staggnet reading.
Car is running a Ford Zetec with standard sensor taken from the thermostat housing.
Haven't tried the fuel gauge yet but I assume that I may come across the same issues, so was keen to rectify one before moving into the next.
Any help/guidance would be greatly appreciated.
Thanks