Hello
My "monitor" SW isn't working
I use Windows XP
I checked the cable.
The COM 1 serial port work whit other applications.
The DL1 is working ok otherwise (except for RPM input)
I can't find any activation of the serial port in the setup.txt file.
Is there any way I can test the DL1 with say a DMM or with the hyperterminal SW to determine if it
Monitor sw not working
Monitor sw not working
Lotus 61 FF1600
Van Diemen RF85 FF1600
Van Diemen RF85 FF1600
Hi Henrik,
You can test it with hyperterminal, set it to 115200 baud, 8 data bits, 1 stop bit, no parity, no flow control. With the DL1 connected to it you should see a copyright message when the DL1 is first turned on. Make sure that you are using the null modem cable supplied with your DL1, you can check the cable by making sure that pin 2 at one end connects to pin 3 at the other end.
The calibration and test is done using the monitor software in the office before units are shipped, so it is very unlikely to be the DL1 not outputting data. You can also test the cable by connecting pin 2 and 3 together on the cable, any characters typed on hyperterminal should then appear on the screen with the short in place, and not without it.
Regards,
Martin
You can test it with hyperterminal, set it to 115200 baud, 8 data bits, 1 stop bit, no parity, no flow control. With the DL1 connected to it you should see a copyright message when the DL1 is first turned on. Make sure that you are using the null modem cable supplied with your DL1, you can check the cable by making sure that pin 2 at one end connects to pin 3 at the other end.
The calibration and test is done using the monitor software in the office before units are shipped, so it is very unlikely to be the DL1 not outputting data. You can also test the cable by connecting pin 2 and 3 together on the cable, any characters typed on hyperterminal should then appear on the screen with the short in place, and not without it.
Regards,
Martin
______________________________
Posted by Race Technology Support
Posted by Race Technology Support
Tested
Hello
conecting #2 and #3 on the Hyperterminal is giving the suggested result. But conecting it to the DL1 it shows rubbish with the text flickering
Does not seem quite right does it..........
Regards
Henrik
[/img]
conecting #2 and #3 on the Hyperterminal is giving the suggested result. But conecting it to the DL1 it shows rubbish with the text flickering
Does not seem quite right does it..........
Regards
Henrik
[/img]
Lotus 61 FF1600
Van Diemen RF85 FF1600
Van Diemen RF85 FF1600
Return to “General support questions”
Who is online
Users browsing this forum: No registered users and 18 guests