GM E67 ECU, Dash2 & CAN OBD - Anyone Used These Together

[356speedster]

I've just joined the forum, having recently purchased a Dash2 & RT CAN OBD interface for my Ultima Can AM build. I'm using an LS3 crate motor, with the full GM E67 ECU & wiring harness.

With the electrics in the car now powered up (engine not started yet), I've started to look at configuring the Dash2 & CAN OBD. The Dash2 is quite straight forwards so far, but I'm struggling with the CAN OBD module.

I'm waiting on a call from Kieran @ RT, but in the meantime, I thought I'd just ask if anyone out there has already used an RT CAN OBD reader sucessfully with the GM E67 ECU? If so, I'd be interested to know the process you've gone through in configuring it, because while I've sucessfully re-flashed the OBD module, I'm struggling to get any any further info out of it, either to any RT s/ware or the Dash2. I can't get any info on the E67's data outputs / config, so I'm sailing a little blind.

If anyone can give me any setup advice, I'd appreciate it.

Thanks, Mark