Analysis Software is Wrongly Putting in Start and End of Run

Noodle30
Posts: 1
Joined: Tue May 07, 2013 9:19 pm

Analysis Software is Wrongly Putting in Start and End of Run

Postby Noodle30 » Wed May 08, 2013 10:29 am

I dont know if Ive selected an option but I was doing some laps at Cadwell and once Ive loaded the data and put a start finish marker, the software puts a start of run and end of run at a random point on the ciruit, rather than sector markers.

The problem is that the gap between these markers is treated as a full lap rather than the complete circuit?

Thanks in advancce

Return to “General support questions”

Who is online

Users browsing this forum: No registered users and 50 guests