DASH3 warning display operation?

SPiFF
Posts: 11
Joined: Fri May 22, 2009 1:56 pm

DASH3 warning display operation?

Postby SPiFF » Mon Aug 25, 2014 3:32 am

I am not really sure I understand how the DASH3 warning function is supposed to work.

So, I can set upper and lower limits for any variable in the software. I can set the warning time in the DASH3 itself.

Then, if the variable is outside the limits, the warning is displayed. For how long??

If I press any button on the dash the warning is cleared. The DASH rechecks 30-sec after the clear. If it is still out of line, the warning will display again.

If I press any button for 1s or longer, the warning will clear until when??? (BTW, holding the button for longer then 1s in the race is not easy!)

What does the "warning time" do?

Let's say the signal goes outside the limit for a brief period, say a few min, what will happen if I don't clear the warning?
Zsolt - #9 ITS GSR

Return to “General support questions”

Who is online

Users browsing this forum: No registered users and 62 guests