Output Driver states

Posts: 53
Joined: Tue Feb 10, 2015 12:08 pm
Location: Surrey, UK

Output Driver states

Postby BiKenG » Sat Jun 13, 2015 11:44 am

Would it be possible to have an output driver control 3 states, e.g. Off - LO - HI?

I want to control something based on ambient air temperature, but the device has 2 states (apart from OFF), LO and HI. Could I somehow use one output driver to turn it on and also to switch its states depending on temperature?

It would appear that PWM mode would have to be used, but could that be used to e.g. control more than one relay at the different required input values (AAT)?
You can't have too many bikes

Return to “General support questions”

Who is online

Users browsing this forum: No registered users and 27 guests