Output driver pins

Moderators: jlucas, RTUSA, kieran

Posts: 53
Joined: Tue Feb 10, 2015 12:08 pm
Location: Surrey, UK

Output driver pins

Postby BiKenG » Tue Jun 16, 2015 9:00 am

With the Output Drivers option I can use 4 of the analog 'channels' as controlled outputs (actually taking pin to ground). By default, these are all on Connector B, leaving the 4 analog inputs on Connector A. This is a problem wiring into the vehicle.

Can I configure the analog input channels 1-4 on Connector A as the Output Drivers and so use the 5-8 on Connector B as the inputs?

The wiki states:-

"The output pins are configured from the Output Drivers icon on the DASH2 PRO configuration software"

which implies I can do this and set which pins I want to use for the Output Drivers, but can I in fact do this and change which analog channels are used for the drivers?
You can't have too many bikes

Return to “General support questions”

Who is online

Users browsing this forum: No registered users and 8 guests