Output driver pins
Posted: Tue Jun 16, 2015 9:00 am
With the Output Drivers option I can use 4 of the analog 'channels' as controlled outputs (actually taking pin to ground). By default, these are all on Connector B, leaving the 4 analog inputs on Connector A. This is a problem wiring into the vehicle.
Can I configure the analog input channels 1-4 on Connector A as the Output Drivers and so use the 5-8 on Connector B as the inputs?
The wiki states:-
"The output pins are configured from the Output Drivers icon on the DASH2 PRO configuration software"
which implies I can do this and set which pins I want to use for the Output Drivers, but can I in fact do this and change which analog channels are used for the drivers?
Can I configure the analog input channels 1-4 on Connector A as the Output Drivers and so use the 5-8 on Connector B as the inputs?
The wiki states:-
"The output pins are configured from the Output Drivers icon on the DASH2 PRO configuration software"
which implies I can do this and set which pins I want to use for the Output Drivers, but can I in fact do this and change which analog channels are used for the drivers?