Dash4/Video4 Y Cable Question

Bikey
Posts: 103
Joined: Fri Apr 29, 2011 6:05 am

Dash4/Video4 Y Cable Question

Postby Bikey » Fri Mar 04, 2016 12:43 am

Hello - I would appreciate if someone could confirm the internal wiring on the Y cable (YCAB001) -- on the DB9 connector that connects to the DL1, does each branch of the cable simply share pins 2 (Rx1), 3 (Tx1) and 5 (GND), with pin 7 (12v) only going to the Dash4 branch?
Or is there a passthrough concept regarding the serial data coming from the Dash 4 and Video 4, with serial out of the Dash 4 routed to the Dash 4, and only the Dash 4 branch of the Y cable connects to pin 2 (Rx1) on the DL1?
Or something else?
I'm planning on a tidy wiring install by using the Binder 719 connectors in place of the DB9s (on connectors not directly connected to RT hardware), with tailored cable lengths.

Thanks.

Return to “General support questions”

Who is online

Users browsing this forum: No registered users and 6 guests