DL1 not logging RPM or Analogs
Posted: Sat Nov 17, 2018 5:33 pm
Hi,
I have 3 DL1 MKII's, 2 of which all appear to be functioning normally but the third one isn't logging any analog channels or RPM.
I have the same SETUP.BIN file in all 3 of them. (Analog 1 to 8 100Hz Flash Card - 1Hz Serial, RPM 100Hz Flash Card - 10Hz Serial)
When I look at the serial data in LiveMonitor I don't see RPM or any Analogue values (I am seeing time stamp, run info, GPS Speed etc) and when I load a run file there is no analogue or RPM data available.
The only difference I can see with this 3rd unit is a sticker on the bottom car that says "Britcar Option". Is this a special version that doesn't log analogs etc? If so can it be reflashed? or do I need to send it back to RT to be 'upgraded' ?
If the "Britcar Option" isn't causing this, what else could be?
Thanks,
Gareth
I have 3 DL1 MKII's, 2 of which all appear to be functioning normally but the third one isn't logging any analog channels or RPM.
I have the same SETUP.BIN file in all 3 of them. (Analog 1 to 8 100Hz Flash Card - 1Hz Serial, RPM 100Hz Flash Card - 10Hz Serial)
When I look at the serial data in LiveMonitor I don't see RPM or any Analogue values (I am seeing time stamp, run info, GPS Speed etc) and when I load a run file there is no analogue or RPM data available.
The only difference I can see with this 3rd unit is a sticker on the bottom car that says "Britcar Option". Is this a special version that doesn't log analogs etc? If so can it be reflashed? or do I need to send it back to RT to be 'upgraded' ?
If the "Britcar Option" isn't causing this, what else could be?
Thanks,
Gareth