Issues connecting Dash2 to PC
Posted: Sun Oct 17, 2021 5:25 pm
I’ve had my Dash 2 a while now but its just developed an issue connecting to my PC if I try and connect from V10 of the software to my Dash it just fails at the sending hardware identification command.
The thing that is baffling me is I am using the same PC as I have always done with a serial port and using a Startech brand serial cable again that I have always used. However the serial port on the Dash is obviously working as it will quite happily read data from my ECU interface and DL1 logger.
I’d welcome any thoughts and suggestions as to the issue.
The thing that is baffling me is I am using the same PC as I have always done with a serial port and using a Startech brand serial cable again that I have always used. However the serial port on the Dash is obviously working as it will quite happily read data from my ECU interface and DL1 logger.
I’d welcome any thoughts and suggestions as to the issue.