Race Technology

Got the remote activation button, but didn't get any wiring info. The button has four wires...red, black, white, and yellow. Need to know where to connect those. I'm guessing one will go to the "Start Logging" terminal and one to the Log Status terminal. Need to know which ones are which and where the other two go. The manual says to connect a switch across the Start Logging terminal and ground, but that's all it says. I can certainly figure *that* part out on my own if I have to, but I'd still like to know what to do for sure with the other two wires (one will go to Log Status, just don't know which one and where to connect the other...likely the +5V ref, I'd think).


--Donnie

Just got a response from Al...for future reference for other folks, here it is:

White - Start Log
Black - Gnd
Red - 12V
Screen(bare) - Log Status


--Donnie

My wiring info was on the bottom of the label on the bag holding the unit. Easy to miss though.