The default scaling is for the Water temp channel is y= +1x. This will display the temp vaules in Celsuis. I would like to display them in Fahreneit.
I know that if X = Celsuis and Y = Fahreneit, then y = x * 1.8 + 32 will give the results need. But how would I enter this into the Dash 2 scaling, enter an equation manually boxes?
I just don't understand the interface.
Dash2 and AEM ECU data scaling?
-
- Posts: 13
- Joined: Mon Apr 12, 2010 4:34 pm
- Location: Houston TX
-
- Posts: 13
- Joined: Mon Apr 12, 2010 4:34 pm
- Location: Houston TX
Return to “Installation questions”
Who is online
Users browsing this forum: No registered users and 10 guests