How to setup RPM input (number of cylinders, etc.)
-
- Posts: 5
- Joined: Mon May 15, 2006 1:59 am
How to setup RPM input (number of cylinders, etc.)
I have a new unit and have connected the MSD 6AL tach lead to the low voltage input of the DL1 and the subsequent RPM values are in error. I suspect there is a configuration somewhere which one enters the number of cylinders (8 in my case) or pulses per revolution. Can someone tell me where this information is entered?
Thanks,
Gary
Gary
Return to “Installation questions”
Who is online
Users browsing this forum: No registered users and 20 guests