4 part connection

DMKMM
Posts: 103
Joined: Thu Apr 17, 2008 12:12 pm
Location: Lincoln, NE

4 part connection

Postby DMKMM » Mon Jul 30, 2012 4:08 pm

Hello, trying to hook up a "full" system.

IMU06, DL2, VIDEO4, DASH4Pro

2 "y" serial cables, both cables are the same (externaly)
the single end female, and the double end one male and one female

and one gender changer male to male


IMU, set to "pass through RT message format" IMU was re-configed using "power injector cable"

DL2 setup, full 100hz on serial and memory card, accel and gyro disabled to account for usage of IMU

Video4 set up, "set all outputs to typical display settings"

DASH4, have display set up, using .hex file

i have the system connected per instructions of video4 instruction manual, 4.5.6 Video4, DL1, ECU, DASH2 assuming the IMU takes the place of ECU

we did have to use a gender changer to connect the dash to the system, the dash info being supplied by the video 4

my thinking that the data flow is as follows

IMU06 sends information to DL2 (DL2 collects analog singals), all data is then sent to VIDEO4, then data is sent to DASH

IMU 06->DASH->VIDEO4->DASH4

IMU set to 100hz output (with pass through enabled)
DL2 set to 100hz output, both serial and card, (accel and gyro disabled)
VIDEO4 set to 5hz output to dash
DASH recieves info

in this system, video recieves no serial data (light on front of unit is not ilumnated), thus DASH recieves no data

IMU + DL + DASH = no prob
IMU + DL + VIDEO = no prob
DL + VIDEO + DASH = no prob

IMU + DL + VIDEO + DASH = nothing

Return to “Installation questions”

Who is online

Users browsing this forum: No registered users and 19 guests