Hi @ all!
last week i got my new DL2 with a Dash2.
I did all the cable-installs....charged the accu....and so on.
connected the DL2 and Dash2, but no data is displayed from the DL2 (Long./Lat./Tot. accerleration).
I check the setup.bin (was configurated to communicate with the dash2).
It doesn't work!
But something was strange, the "Log-LED" is always red, and the "Lock-LED" doesn't glow.
Does this mean i have no GPS satellite loged on?
However, i connected the dash2 to the RS232 of my laptop, and tried to get some data with the "lite monitor"- it worked!
the i connected the DL2 - nothing!
The transmit-pin is always on -6,4VDC (this means it is disabled).
But if i flash a new firmware, the transmit-pin is sending a signal to the pc, which is the same during the flashing process.
after flashing the pin retours to -6,6VDC.
My conclusion:
the hardware works, because i can flash a new firmware and the transmit-pin can change his signal.
But it seems, that the firmware gets stuck during booting and cannot read the setup-bin on the CF-card....
Has somebody a solution for this problem?
How can i perform a hardreset?
to be honest, it's an unbounded cheek to sell such an expensive system without (!!!) a manual!
@support:
i bought this unit over "Agostec" in germany, i think you already have contact with them...?
new DL2 + Dash2
-
- Posts: 5
- Joined: Fri Sep 14, 2012 10:30 am
- Location: Austria
- Contact:
-
- Posts: 5
- Joined: Fri Sep 14, 2012 10:30 am
- Location: Austria
- Contact:
i also think that the DL2 gets stuck while "booting" up.
Disconnectiong all connections didn't help. the leds "on", "Status" are glowing green and "log" is glowing red.
when i insert the CF-card, "status" and "log" are flashing for 2 seconds.
but the serial port will not be enabled....so i think it is not loading the setup.bin......
i retourned the DL2 to Agostec, they will retour it to you.
Disconnectiong all connections didn't help. the leds "on", "Status" are glowing green and "log" is glowing red.
when i insert the CF-card, "status" and "log" are flashing for 2 seconds.
but the serial port will not be enabled....so i think it is not loading the setup.bin......
i retourned the DL2 to Agostec, they will retour it to you.
-
- Posts: 5
- Joined: Fri Sep 14, 2012 10:30 am
- Location: Austria
- Contact:
i think Mr. Bartelborth from Agostec had already contact with you and gave you all this information.
other question:
normally every electronic device is able to perform a hardreset....by pushing a few buttons at the same time.
i got no answer, how to perform a hardreset....
so i thought a reflash of the firmware will force the DL2 to do a hardreset...?
other question:
normally every electronic device is able to perform a hardreset....by pushing a few buttons at the same time.
i got no answer, how to perform a hardreset....
so i thought a reflash of the firmware will force the DL2 to do a hardreset...?
-
- Posts: 5
- Joined: Fri Sep 14, 2012 10:30 am
- Location: Austria
- Contact:
-
- Posts: 5
- Joined: Fri Sep 14, 2012 10:30 am
- Location: Austria
- Contact:
Return to “Installation questions”
Who is online
Users browsing this forum: No registered users and 16 guests