Hi all,
I have a dl1 club and recently bought a lead from race technology to connect to my emerald k6 ecu. I have just received the cables but there 3 connections as follows:
Rs232 one
Rs232 two
Can port interface
Reading the website and emerald site - I am not 100% which one I use to go into the comms port on my ecu.
Separately the length of the cables is very short and where my ecu is mounted it would mean I would need to either mount the data logger on the floor or on the transmission tunnel cover both are pretty exposed in a Westfield.
So final question can I extend the cable? Or do race technology provide a longer cable?
Sorry to ask what are probably noddy questions but just keen that I get it right rather than damage the data logger or more importantly my ecu.
Any help would be much appreciated
Thanks
Pete
Emerald ecu connection
-
- Posts: 5
- Joined: Wed Jan 15, 2020 7:54 pm
Emerald ecu connection
- Attachments
-
- 334567C4-278C-465A-9ADD-BB52011728DE.jpeg (152.27 KiB) Viewed 28441 times
-
- D87974DE-AA9B-46EC-8581-9330398A253E.jpeg (97.9 KiB) Viewed 28441 times
Re: Emerald ecu connection
Hi Pete
Please see below knowledge base page regarding connections:
https://www.race-technology.com/wiki/in ... 3AndK6-CAN
If you have any further questions please email support at race-technology dot com.
Support (AH)
Please see below knowledge base page regarding connections:
https://www.race-technology.com/wiki/in ... 3AndK6-CAN
If you have any further questions please email support at race-technology dot com.
Support (AH)
-
- Posts: 5
- Joined: Wed Jan 15, 2020 7:54 pm
Re: Emerald ecu connection
Ok thanks I have emailed yourselves at race tech
Return to “Installation questions”
Who is online
Users browsing this forum: No registered users and 242 guests