I am slowly trying to get all the functionality working on my DASH2 Pro in my race car and have added the four steering wheel buttons and am trying to get the "Add Marker" function working for my next track outing.
However, I seem to have found some conflicting, or at least not very clear, information. In the installation guide it references these as DOWN (Connector A pin 3), UP (Connector A pin 4), MENU (Connector A pin 9) and SELECT (Connector A pin 10). However in the programming guide...
https://www.race-technology.com/wiki/in ... trolInputs
This guide shows the programming for extra buttons and says that in unit control inputs that the SET button is programmed as Add Marker by default. But the default buttons are UP, DOWN, MENU & SELECT. I dont see any wiring for a "SET" button.
Can anyone confirm, as I suspect, that the SET button listed in the software, is actually the SELECT button?
Thanks
DASH2 Pro Hardware Buttons
Re: DASH2 Pro Hardware Buttons
Correct. "Set" and "select" are used interchangeably.
______________________________
Posted by Race Technology Support
Posted by Race Technology Support
Re: DASH2 Pro Hardware Buttons
Many thanks for confirming
Return to “Installation questions”
Who is online
Users browsing this forum: No registered users and 139 guests