Hi
Dash 2 with Fuel/Oil pressure Racetech sensors, all wired correct and checked, dash does not read them on analogue channels???
I'm baffled
Newbie Baffled Need Help Sensors
stripped everything back again just to make sure, ran each sensor individually on dash 2 ( still no 5v )
so utilised 5v and sensor ground from DTA S40
1st sensor tested EGT kit 5v short 2519ma
2nd fuel pressure no issues
3rd oil pressure no issues
4th oil temp no issues
ran a few range tests on the 3 working sensors all seem to work fine and show correct readings
EGT Kit is at fault it appears tested with and without sensor connected to amp box same result showing a short ground warning at 2529ma
so utilised 5v and sensor ground from DTA S40
1st sensor tested EGT kit 5v short 2519ma
2nd fuel pressure no issues
3rd oil pressure no issues
4th oil temp no issues
ran a few range tests on the 3 working sensors all seem to work fine and show correct readings
EGT Kit is at fault it appears tested with and without sensor connected to amp box same result showing a short ground warning at 2529ma
Return to “Sensor-related questions”
Who is online
Users browsing this forum: No registered users and 15 guests