Honeywell MLH Pressure Sensors - resistor needed?
Posted: Wed Apr 14, 2010 5:32 pm
I'm planning to use Honeywell MLH pressure sensors for F&R brake pressure and fuel pressure.
http://sensing.honeywell.com/index.cfm/ ... /1/re_id/0
The models I'm using require a +5V input and output 0.5V to 5V. Since the sensor output is voltage, I would assume I do not need a pull up/down resistor. Is this correct?
http://sensing.honeywell.com/index.cfm/ ... /1/re_id/0
The models I'm using require a +5V input and output 0.5V to 5V. Since the sensor output is voltage, I would assume I do not need a pull up/down resistor. Is this correct?