Page 1 of 1

Emerald k6 oil pressure on dl1mk3 using can

Posted: Sat Jun 16, 2018 2:31 pm
by jim0087
Hi all, has anyone managed to read oil pressure from an emerald k6 via can bus? I can see the oil pressure in the ecu. The data is there on the logger but value only 1? Does anyone know the configuration settings to read the can data? All other channels work ie rpm, water temp, afr, throttle position, battery voltage all arriving via can bus. Any advice greatly appriceated

Re: Emerald k6 oil pressure on dl1mk3 using can

Posted: Mon Jun 18, 2018 1:21 pm
by Support
Hello,

This is the available channels being transmitted by the Emerald ECU when generic mode is selected. Unfortunately, oil pressure is not available.
http://www.emeraldm3d.com/media/softwar ... otocol.pdf

If it is possible to set up a custom CAN output that you can set which channels to output then yes it is possible. Are you able to set anything like that in the ECU software?

Support (K)

Re: Emerald k6 oil pressure on dl1mk3 using can

Posted: Wed Jun 27, 2018 8:50 pm
by jim0087
Dan has helped me with this. Once I followed the process Dan suggested it worked! Looks amazing cheers guys