I'm planning to use Honeywell MLH pressure sensors for F&R brake pressure and fuel pressure.
http://sensing.honeywell.com/index.cfm/ ... /1/re_id/0
The models I'm using require a +5V input and output 0.5V to 5V. Since the sensor output is voltage, I would assume I do not need a pull up/down resistor. Is this correct?
Honeywell MLH Pressure Sensors - resistor needed?
Honeywell MLH Pressure Sensors - resistor needed?
Billy
98 Prelude - #27 NASA TX PT
98 Prelude - #27 NASA TX PT
Return to “Sensor-related questions”
Who is online
Users browsing this forum: No registered users and 14 guests