Call me back | My basket | Checkout | Add to email list

     You are here: Website » Knowledge base

« back to website

ConfiguringTheDASH3Unit / ChangingTheExistingConfiguration

Changing the existing configuration

If you want to change the existing configuration and you already have the current configuration information saved into a DH3 file, simply load it using the File -> Load Layout command of the configuration software.

If existing configuration is not present as a DH3 file, then use File -> Read Configuration from Device command to read the configuration from the DASH3. After the reading, make changes to the configuration and remember to save it for one of the following two formats.

DH3 format
If you need to load and change the configuration later you must save the configuration into this format.(Use File -> Save Layout command. There are no restrictions on the file name.)
HEX format
When updating the DASH3 configuration using the Datalogger, saving to this format is required. Files in HEX format cannot be loaded into the Configuration software for further changes.
Page last modified on March 07, 2012, at 03:51 PM