Call me back | My basket | Checkout | Add to email list

     You are here: Website » Knowledge base

« back to website

ECUType / DTAS40PROS60PROS80PROS100PRO


DTA S40 S60 S80 S100


Compatibility


  • DTA S40PRO
  • DTA S60PRO
  • DTA S80PRO
  • DTA S100PRO


Configuration


To set up the ECU, open the DTASwin software and connect to the ECU. In the Other Map Settings > Data Stream options, set up the unit as shown in the below image. Send the new map settings to the ECU, this can be done by pressing F4.


Connections


These ECU should be connected via CAN connections:



S40PRO:


  

S60PRO:


  

S80PRO:


  

S100PRO:

Data Channel Listing:

ECU Message Name Race Technology Data Channel Resolution of Data
RPM RPM (Engine RPM) 1 RPM
TPS% Throttle position (aux 1) 1%
Water temp Coolant temp (temperature 8) 1oC
Air temp Ambient air temp (temperature 1) 1oC
MAP Boost pressure (pressure 5) 0.1 kPa
Lambda Lambda 1 (misc 1) 0.001 lambda
Vehicle speed Speed from the ECU (misc 4) 1 MPH
Oil pressure Oil pressure (pressure 2) 0.1 kPa
Fuel pressure Fuel pressure (pressure 3) 0.1 kPa
Oil temp Oil temp (temperature 9) 1oC
Battery volts Battery voltage (misc 3) 0.1V
Ignition angle Ignition angle (angle 2) 0.1o
Injection time Fuel inj 1 PW on (measured time 1) 0.01s
Fuel con Auxiliary 1 (aux 26) 0.1 L/100Km

Not all channels listed in the table above may be available from your ECU. The available data channels vary with the vehicle model, year of manufacture & connected sensors.

Page last modified on August 19, 2020, at 01:05 PM