Call me back | My basket | Checkout | Add to email list

     You are here: Website » Knowledge base

« back to website

GoProStandalone / Installing

Installing

Download the V10 software package from the Race Technology website and click on the downloaded file to begin the installation. The installation package will start up as shown below.

Click "Next" to proceed

You are required to agree to the Race Technology Ltd Software Licence Agreement, take you time to read the agreement, and select "I accept the terms in the licence agreement" to proceed.

Select the installation location (or leave as default), and select location and size of Swap file (or leave as default). The swap file is used to hold data used in the Analysis software and the size of it dictates the maximum length of files that can be loaded. The size of the swap file can be changed later if required in the Analysis software.

Click "Next" to proceed.

There are four installation options. Select the bottom right button to proceed with the GoPro Only mode installation.

Select the units you prefer to use, then click "Next" to proceed

That completes the set up of the installation, click "Install" to begin the installation.

Once complete the installation will state that the software was successfully installed.

Please restart your computer to complete the installation.

To launch the software look for "Race Technology V10"

Page last modified on July 23, 2019, at 11:26 AM