DASH2 RPM not displaying
Posted: Wed Mar 15, 2017 10:46 am
Hi
I am new to this forum and seeking some assistance in configuring the RPM display on a DASH2. (standalone)
The RPM signal is a clean 33-40Hz 12 volt square wave at idle.
1k pull up to +12 volts, version 9.1.7 firmware
ECU is standard Subaru WRX 2005. The motor is in a custom manx style buggy.
Attached is the configuration of the RPM setup.
I have tried with no success, adding filtering, averaging.
the only time I see the RPM scale appear is on startup for a few seconds and then it goes back to 0.
All other programing seems to work fine
Signal has been checked, and wiring checked to connector 1, pin C
I am new to this forum and seeking some assistance in configuring the RPM display on a DASH2. (standalone)
The RPM signal is a clean 33-40Hz 12 volt square wave at idle.
1k pull up to +12 volts, version 9.1.7 firmware
ECU is standard Subaru WRX 2005. The motor is in a custom manx style buggy.
Attached is the configuration of the RPM setup.
I have tried with no success, adding filtering, averaging.
the only time I see the RPM scale appear is on startup for a few seconds and then it goes back to 0.
All other programing seems to work fine
Signal has been checked, and wiring checked to connector 1, pin C