Hi all
I'm trying to setup my DL1 Club to work with my Emerald K6+ ECU. I have my DASH4 wired into serial port 1 and the ECU into serial port 2 but I'm not receiving any data.
When I reflash the DL1, I receive a warning message saying:
ECU interface has been selected but not enabled in device
Does this mean my ECU isn't configured to decode the serial data internally? I bought the unit second hand and was told it was able to do so
I have an external ECU serial adaptor (configured for the Emerald) - I guess I can I use that instead. I now don't know if the second serial port has been enabled on the logger so I guess the ECU would have to feed into serial port 1.
I've messaged RT but it is Christmas Eve so I don't expect a response for a while and I was hoping to get this done while I have a break from work!
Many thanks
Wyn
Emerald K6+, Dl1 Club and Dash4 problems
Re: Emerald K6+, Dl1 Club and Dash4 problems
Hi Wyn
I have responded to your email. Please do not hesitate to contact us if you require any further assistance.
Support (AH)
I have responded to your email. Please do not hesitate to contact us if you require any further assistance.
Support (AH)
Re: Emerald K6+, Dl1 Club and Dash4 problems
All sorted - great service from RT!
Return to “General support questions”
Who is online
Users browsing this forum: No registered users and 31 guests