Hi,
I have a Dash2pro in a Lotus Elise Mk2 w Rover engine (no CAN-bus). For 2000 km it worked perfectly. Yesterday I changed the display screen1 a bit. Water temperature was moved to the middle and the right display is now used for RPM using the variable "RPM {Engine RPM}[Hz](RPM)". Since then there is no rpm on the large scale and no rpm in the right digital display.
In "Wheelspeed and RPM" max rate of change is 0, smoothing time is 0,02sec and pulses per rev is 2. Internal RPM Enable is checked and low RPM is selected. Nothing was changed here by me.
Anybody an idea what could have happened and how I get RPM back?
TIA, Karl
no RPM display after config change
no RPM display after config change
Lotus Elise S2 w Rover engine, Dash2 pro
Re: no RPM display after config change
After two days without using the car RPM works again
Lotus Elise S2 w Rover engine, Dash2 pro
Return to “General support questions”
Who is online
Users browsing this forum: No registered users and 22 guests