Call me back | My basket | Checkout | Add to email list

     You are here: Website » Knowledge base

« back to website

ECUType / SyvecsCAN

Syvecs CAN

Note: The Syvecs S6Plus is normally supplied as a PnP installation with different CAN config to match the OE ECU. The Race Technology supplied CAN adapter is compatible only with the default Syvecs CAN output, as applied to the S6GP ECU.

Connections

  • CAN+ pin 82 (CAN1+) of the 88 pins connector
  • CAN- pin 81 (CAN1-) of the 88 pins connector

ECU settings

To enable ECU communication it is necessary to set some ECU parameters using “SCal” software:

SyvecsCanCal.SC file is available from Race Technology at request. This will automatically load the correct CAN settings. Below is the setting if you wish to entre manually.




Channel Listing:

ECU Name Race Technology message Race Technology Default name Race Technology VAR number Resolution
rpm_S Engine RPM RPM VAR_0010 1 RPM
vbat_S misc 3 Battery voltage VAR_4002 0.001 mV
lam1_S misc 1 Lambda 1 VAR_4000 0.001 Lambda
egt1_S temperature 17 Exhaust 1 temp VAR_1016 0.1C
ect1_S temperature 8 Water temp VAR_1007 0.1C
act1_S temperature 6 Inlet post intercooler 1 VAR_1005 0.1C
calSwitch_U aux 26 Auxiliary 1 VAR_2025 N/A
rlSpeed_S aux 29 Auxiliary 4 VAR_2028 0.1MPH
eop1_S pressure 2 Oil pressure VAR_3501 1mb
eot_S temperature 9 Oil temp VAR_1008 0.1C
tcSpinTarg_S aux 28 Auxiliary 3 VAR_2027 N/A
ppsA_S aux 1 Throttle position VAR_2000 0.10%
flSpeed_S aux 27 Auxiliary 2 VAR_2026 0.1MPH
fp1_s pressure 3 Fuel pressure VAR_3502 1mb
Page last modified on January 30, 2018, at 02:54 PM