Call me back | My basket | Checkout | Add to email list

     You are here: Website » Knowledge base

« back to website

DASH2PROInstallation / PhysicalInstallationOfDASH2PRO

Physical installation of the Display Unit

The DASH2 PRO must be securely mounted onto flat surface or suitable bracket. When deciding on a mounting location it is important to position the viewing angle for the best display contrast. The display can be clearly read over a wide range of incidence angles, but it is most clearly viewed from an angle of approximately 10-20° above the display axis.

A printed template has been provided and should be used to check that there is sufficient space for mounting the unit. There should also be room for drilling the clearance holes for the fixing screws, the electrical connections and the GPS connector. All three mounting holes should be used to prevent the unit from loosening under vibration. In addition, the use of a low strength thread locking compound is recommended for installations in a high vibration environment. Mounting requires M4 fasteners with a thread engagement depth of 5mm. Avoid over tightening the mounting screws to prevent thread damage.

A mounting template is available to download here

Page last modified on August 16, 2016, at 10:57 AM