Call me back | My basket | Checkout | Add to email list

     You are here: Website » Knowledge base

« back to website

ConfiguringAnalogModule8 / ConfiguringForUseWithDL1Mk3-Club-Pro-WPAndDASH2PRO-DASH4PRO

Configuring for use with DL1 Mk3/Club/Pro/WP and DASH2 PRO/DASH4 PRO


When using the ANALOG8 with DL1 Mk3/Club/Pro/WP and DASH2 PRO. The default configuration shipped on the ANALOG8 can be used. The analogue inputs on the above units are able to be mapped, care must be taken to ensure the built in analog inputs found on these units are not mapped to the same channels found in the ANALOG8.

For DASH4 PRO the default configuration shipped on the ANALOG8 can be used, the DASH4 PRO should be configured to suit the channels incoming from the ANALOG8 to ensure the correct data is displayed.

If any of the above units are also connected to a DL1 Mk1/Mk2/Sport data logger, please consult the information found here for how to configure the module.

Page last modified on January 25, 2019, at 01:45 PM