Call me back | My basket | Checkout | Add to email list

     You are here: Website » Knowledge base

« back to website

DASH2PROInstallation / SwitchInputs

Switch inputs

Four buttons should be connected to the DASH2 PRO to allow in-vehicle control of many functions and display options. These buttons are required to set certain display functions and options, as described in Programming soft buttons. Momentary push-to-make buttons should be used. These are available from Race Technology or from any good electrical or automotive component supplier. Each button must be wired with one terminal connected to the switch Ground and the other terminal connected to the relevant DASH2 PRO switch input. The Switch Ground pin and four switch input pins are all included in Connector 1, as shown below.

Pin No Description Range Wire Colour
3 DOWN switch input 0v to activate Red/Black
4 UP switch input 0v to activate Slate Grey
7 Switch Ground   Yellow
9 MENU switch input 0v to activate Red
10 SELECT switch input 0v to activate Orange


Connector A orientation and 24 Way Cable:

Page last modified on January 30, 2015, at 07:50 AM