Call me back | My basket | Checkout | Add to email list

     You are here: Website » Knowledge base

« back to website

LapTimingGuide / ConfiguringDL1-DASHx

Configuration information for setups with DL1+DASHx (no VIDEO4)


Information about how to set up this configuration are included here.

However, the most important points to check are:

  • For reasons described above, although all firmware versions of the DL1 support lap timing it is strongly recommended that you run firmware 32 or later to maximise reliability.
  • Also note that in the case of the DASH1 and the DASH2 it is very important that the data rates out of the VIDEO4 are set appropriately. If the data rates are set too high then the input data buffers on the DASH1 and the DASH2 can get overloaded which can cause problems. All default layouts supplied for the VIDEO4 are preconfigured, but it is important to check just in case. There is more information about this here.
Page last modified on November 25, 2013, at 11:32 AM