Call me back | My basket | Checkout | Add to email list

     You are here: Website » Knowledge base

« back to website

DASH2PRO-HowDoI / ReflashTheUnitFromAPC

How do I re-flash my DASH2 PRO?

By re-flashing your DASH2 PRO, the latest software will be installed onto it. Typically, this is only required when requested by the factory to address an issue in the firmware. Note there is a small risk when re-flashing the DASH2 PRO that you will corrupt the unit. If you are re-flashing the unit following an instruction from the factory, then this will be covered within the standard warrantee - if however you are re-flashing the unit without being instructed to then you will be charged for the factory to reset the unit. We would recommend that you don't re-flash the unit unless it is required.

Step 1: Apply power to the DASH2 PRO.

Step 2: connect your DASH2 PRO to your PC using a USB cable.

Step 3: Start up the DASH2 PRO configuration software, in the communications section at the bottom of the main screen select the correct serial port for the USB connection to the DASH2 PRO. Then select File / Reflash DASH2 PRO Firmware. The following screen appears:

  

Click on the box with three dots and select the .rmg file for reflash

Step 4: Click on Reflash and the reflash should start.

Page last modified on November 19, 2013, at 10:59 AM