Default Configuration
The DL1 CLUB can be configured by direct connection to a PC through the USB port or by loading the configuration file on to the SD card which is put in to the unit. The unit has a default configuration from the factory. This configuration has the following settings for the analogue channels:
- Spare input
- Fuel level
- Boost pressure
- Air temperature
- Oil pressure
- Oil temp
- Water temp
- Start / stop control
- If the output driver option is enabled, the port 12 is used as the status output.
- Frequency inputs are set to map to wheel speeds 1-4, the high level RPM input is enabled.
- All channels are transmitted on the serial port and all channels are logged to the SD card.
- Automatic starting and stopping of logging are disabled.
If you need to change any of these configuration, start up the DL1 CLUB configuration software.
Full instruction on how to configure the unit can be found in the online help which is installed with the Analysis software package.
NOTE: The default configuration will need to be changed if the unit is used with an ECU interface, failure to change this will result in no readings for any of the channels listed above.